Holybro PM02D 2-6S Power Module w/XT60 Plugs for FPV Racing RC Drone

Holybro PM02D 2-6S Power Module w/XT60 Plugs for FPV Racing RC Drone

PM02D provides regulated power supply for your Pixhawk 5X & 6X from the battery, as well as current consumption and battery voltage measurements, all through a 6pin cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from LiPo batteries up to 6S. The Power Module comes completely assembled with XT60 connectors, wrapped in shrink tubing for physical damage protection.
It is not designed to power servos, please use your aircraft’s ESC/BEC for that. The Molex 2.00mm pitch CLIK-Mate Wire-to-Board connector is rated for 3.0A current per contact.
Note: PM02D uses I2C digital signal data output and not compatible with Pixhawk 6C, Pixhawk4, Pixhawk4 Mini, pix32 v5, or Durandal flight controllers.
Description:
Input voltage: 2S – 6S
PCB Cont. Current Rating: 60A
PCB Burst Current Rating: 100A (<60 Sec)
Max current sensing: 164A
Voltage and current monitor with I2C compatible interface
Outputs 5.2V and 3A max
Weight: 20g
Current Rating:
The PM02D comes with XT60 plugs with 14 AWG silicone wires rated for 30A continuous current and 60A burst current (<1 minute).
Package Included:
1x PM02D Power Module
1x 6pin 2.00mm pitch cable

Additional information