Happymodel SuperX HD ELRS 1-2S AIO Flight Controller with 12A ESC & UART ELRS Receiver for Digital Whoop RC Drone FPV Racing

Description

Happymodel SuperX HD ELRS 1-2S AIO Flight Controlelr Built-in 12A ESC and UART ELRS Receiver for Digital Whoop RC Drone FPV Racing

The Happymodel SuperX HD ELRS 1-2S AIO Flight Controller is designed for digital Whoop RC drone FPV racing enthusiasts. This controller features the SuperX HD ELRS with Betaflight 4.4.2 firmware, equipped with an STM32F411CEU6 MCU for optimal performance. It supports a 1-2S LiPo/LiPo HV power supply and includes a built-in 12A 4in1 ESC with Dshot300 support. Additionally, it has a built-in UART ELRS receiver, ready for ExpressLRS V3.0, with WiFi and pass-through firmware update capabilities. The controller is compatible with ESC-Configurator and BLHELI_S Suite configurator for customization. Please note, good soldering skills are required as motor plugs are not pre-soldered.

Notes:
Before buying this flight controller, make sure you have good soldering skills and can solder tiny pads.
Any flight controller failure caused by welding errors is not covered by the warranty. The motor plugs didnot
pre-solder in our factory.
Specifications:
Brand: Happymodel
Model: SuperX HD ELRS

Flight controller
SuperX HD ELRS

Betaflight 4.4.2 firmware ready
Firmware target: CRAZYBEEF4DX
MCU:STM32F411CEU6 (100MHz, 512K FLASH)
Sensor: BMI270 or ICM42688P (SPI connection)
Power supply: 1-2S Lipo Lihv battery input (DC 2.8V~8.7V), only support 1s input for this drone
Built-in 12A(each) Blheli_S 4in1 ESC Dshot300 read
Built-in UART elrs receiver , elrs v3.0 ready, support WIFI and pass-through firmware update
Bluejay ESC Firmware ready
Built-in 5V 1A BEC
Built-in voltage detection
No betaflight analog osd chip

Onboard 4in1 ESC

Power supply: 1-2S LiPo/LiPo HV
Current: 12A continuous peak 15A (3 seconds)
Support ESC-Configurator and BLHELI_S Suite configurator
Factory firmware: Z-H-30 – Bluejay, 0.19, 48kHz
Default protocol: DSHOT300

Onboard UART ExpressLRS 2.4GHz Receiver

RF Frequency: 2.4GHz
Antenna: enameled copper wire 31mm length
Telemetry output Power: <12dBm
Receiver protocol: CRSF
Default firmware version: ExpressLRS V3.0.1
The same hardware with Happymodel EP1 receiver
Could update firmware via ExpressLRS configurator or WIFI or Betaflight pass-through

Package Included:
1 x HappyModel SuperX HD ELRS 1-2S AIO Board